SlotInvasionUSA MPL QX2021 Rev.3- Wired Plug & Play-Digital chip Carrera(R) compatible- up to 18.5V.

SlotInvasionUSA MPL QX2021 Rev.3- Wired Plug & Play-Digital chip Carrera(R) compatible- up to 18.5V

NEW REV3 NOW WITH PRE_WIRED PLUGS & IR Sensor! MPL QX2021 Rev.3–by MPL Germany– Carrera Digital(R) 1/43, 1/32 and 1/24 – compatible decoding chip. – the smallest 18.5 Volts chip in the market.
The slimmest!- only 3mm (0.11″) tall/thick- ideal for F1, low bodies and tight spaces.

Smaller!- 0.96″ (24.5mm) long by 0.59″ (15mm) wide- install anywhere- chassis, body etc.

Flexible!-  Flat bottom side (no protruding components) for a flat easy to mount surface.

Lightweight!- only 0.05 ounces (1.6g) – Net Weight without wires/plugs

– Convert and upgrade any brand of slot car to be compatible with Carrera Digital slot tracks.

–  NEW-Ultra flex silicone wires with compatible JST style plugs for power/motor, IR Sensor and lights- now pre installed!

– NEW- Flashing headlights function (aka passing/overtake signal lights) – just depress change lane controller button while driving to activate- Le Mans style!

– 10 speed and brake levels with Carrera CU’s, (16 steps with Cockpit-XP or Open Lap)

– Maximum operating voltage: 18.5V, Minimum, 12v

– Head and tail lights and separate brake lights functions ready and capable

– Pitlane function and Ghost car can only be used in conjunction with Carrera Digital Control Unit (CU) 30352.

– REV.3-Higher capacity Mosfet- can be used with 18D and high performance tuning motors

Kit includes:

1 MPL Digital Decoder QX2021 Rev.3

2 sets of extra wire/plugs extensions to facilitate installation

1- Instruction sheet in English

LED Lights, capacitors… if desired but not needed for operation-NOT INCLUDED

This is the ideal chip for the -DYI serious slot racer!- fine tip soldering iron, solder, hot glue or double sided foam mounting tape needed to complete installation- NOT INCLUDED.